-
Legacy Member
M1 carbine butt plate
Hello, I thought about posting this on the m1 carbine section of this forum but there doesn't seem to be a lot of activity over there so I will post this here to see if I can get any opinions if I'm correct or not. I have a used butt plate that after researching, seems to indicate Saginaw to me. Am I correct or flat out wrong ? Thanks in advance
"good night Chesty, Wherever You Are"
-
Thank You to jond41403 For This Useful Post:
-
09-07-2024 08:27 PM
# ADS
Friends and Sponsors
-
D@mn You JD,
Was planning on relaxing today and watch the race after wrestling out the old dishwasher and putting the new one in for the Wife yesterday.
But Nooooooo ! you gotta post a Buttplate.
I was going to call your's the late WRA, but then seen the extra space between the Dots between the 10 to 12 position. Looked over the CCCF plate ID page and decided your's matches the plate used by both SG and Inland.
SG / Inland
http://www.uscarbinecal30.com/parts/...utI3center.jpg
The late WRA
http://www.uscarbinecal30.com/parts/...utW1center.jpg
Charlie-Painter777
A Country Has No Greater Responsibility Than To Care For Those Who Served...
-
The Following 3 Members Say Thank You to painter777 For This Useful Post:
-
-
Legacy Member
Hahaha, sorry Charlie! At least that's the last part I have that I have questions about haha. As usual Charlie, thanks again, you are the man!
"good night Chesty, Wherever You Are"
-
Thank You to jond41403 For This Useful Post: